How To Light Rv Furnace Pilot Light

So, you've just hitched up your RV, ready for a weekend of adventure. You've checked the tires, the hitch, even the emergency road kit. But as the sun sets and the temperature drops, you realize you've forgotten to check one crucial thing - the furnace. You're not about to let a little chill stop your fun, are you? Let's dive into how to light that RV furnace pilot light, shall we?

First Things First

Before we get our hands dirty, let's talk safety. Gas leaks are no joke, so if you smell gas, do not try to light the pilot light. Get out of your RV, call your campground host or a professional immediately. Once you've got the all-clear, we can proceed.

Locating the Pilot Light

Alright, where's that pesky pilot light hiding? It's usually located at the bottom of the furnace, near the floor. You might need to move a panel or two to get to it. Don't worry, it's not as complicated as solving a Rubik's cube. Once you've found it, you'll see a small tube with a flame dancing at the end. That's your pilot light.

Preparing for Liftoff

Now, let's get ready to light that bad boy. First, turn the furnace control valve to the 'Pilot' setting. You'll see three settings usually - 'Off', 'On', and 'Pilot'. We want 'Pilot'. Next, locate the reset button. It's usually a small, red button near the control valve. Don't touch it just yet, we're not quite ready.

Time to Spark Joy

Grab a long match or a lighter. You'll need to reach in and light the pilot light. Be careful, the tube can get hot. If you're feeling a bit clumsy today, don't worry, there are those long, skinny grill lighters that work perfectly for this. Now, press and hold the reset button. While holding it down, light the match or lighter and bring the flame to the pilot light opening. You should see a flame ignite. Keep holding the reset button for about 30-60 seconds to allow the thermocouple to heat up.

How to Relight the Pilot Light on Your Furnace: Step-by-Step Guide

Testing, Testing

Once you've let go of the reset button, the furnace should stay lit. If it goes out immediately, you might have a problem with the thermocouple. It's the little sensor that tells the gas valve to stay open. If it's not working, you'll need to replace it. But don't worry, that's a job for another day. For now, let's assume our thermocouple is working just fine.

Now, turn the furnace control valve to the 'On' setting. You should hear the furnace kick on, and warm air should start blowing through your vents. If all is well, give yourself a pat on the back. You've just conquered the art of lighting an RV furnace pilot light!

How To Light A Furnace Pilot Light (DIY! Save $$ and Time) - YouTube

One Last Thing

Before you settle in for the night, double-check that the furnace is working properly. Turn the thermostat up a bit and make sure you feel warm air coming from the vents. And remember, safety first. If something doesn't feel right, don't hesitate to call a professional.

Now, go ahead, pour that glass of wine, put your feet up, and enjoy your cozy RV night. You've earned it!